[DUG] XE8 with Castalia and MMX

[John Bird]

Yes uninstalling MMX or disabling Castalia (using /NOCASTALIA command line option) fixes the issue of access violation.

Don’t have a solution that allows both on some PCs.

It is possible that the IDE was not run before installing MMX on the PCs with the issue – it was run on one of the PCs where Castalia and MMX are working OK, which means that there may be no solution apart from reinstalling the IDE...

From: razal ka 
Sent: Thursday, June 4, 2015 4:04 PM
To: NZ Borland Developers Group - Delphi List 
Subject: Re: [DUG] XE8 with Castalia and MMX

Hi John, 

Did you try removing MMX. When I first installed XE8 I had similar issue and the reason found was the MMX. We reported the error to Model Maker and they suggested us to first install XE8 run the IDE once before installing MMX. 

This step fixed the issue for me.

Thanks
Razal

On Thu, Jun 4, 2015 at 1:14 PM, John Bird <johnkbird at paradise.net.nz> wrote:

  XE8 comes with Castalia built in, here 2 of the users have both working, 2 others can have either Castalia or ModelMaker MMX (11.2.0)  installed but not both.
  Castalia can be disabled with /NOCASTALIA on the command line switch.
  Error we get is on IDE startup “Access violation at address 20441561 in module ‘coreide220.bpl’. Read of address 0000003D.”
  Dies at that point.
  (We are already installing everything as Administrator, and running the IDE as same.)
  Can anyone shed any light on the problem or know of any solution?

  _______________________________________________
  NZ Borland Developers Group - Delphi mailing list
  Post: delphi at listserver.123.net.nz
  Admin: http://delphi.org.nz/mailman/listinfo/delphi
  Unsubscribe: send an email to delphi-request at listserver.123.net.nz with Subject: unsubscribe





-- 

Regs
Razal K.A




--------------------------------------------------------------------------------
_______________________________________________
NZ Borland Developers Group - Delphi mailing list
Post: delphi at listserver.123.net.nz
Admin: http://delphi.org.nz/mailman/listinfo/delphi
Unsubscribe: send an email to delphi-request at listserver.123.net.nz with Subject: unsubscribe
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://listserver.123.net.nz/pipermail/delphi/attachments/20150604/652a4f41/attachment-0001.html