[DUG] Control of stepper motors

[Dennis Chuah]

How are the motors connected to the PC?

You can get stepper motor cards that contain all the electronics and some 
smarts to drive the motors.  They come with drivers and it is a matter of 
interfacing D5 with the drivers - a lot easier than designing it all 
yourself.

----- Original Message ----- 
From: "Grant Brown" <grant at sitedoc.com.au>
To: "Delphi mailing list - NZ" <delphi at ns3.123.co.nz>
Sent: Tuesday, October 18, 2005 12:39 AM
Subject: [DUG] Control of stepper motors


> Hi to all,
>
> Using D5
>
> Can anyone recommend a good site that shows how to control a stepper motor 
> from Delphi.
>
> I actually need to control 3 motors across all 3 axis with communication 
> to the stepper motors being via a serial port.
>
> Could anyone recommend any control components ?
>
> Where do I start with this ?
>
> -- 
> Regards,
> Grant Brown
>
> Product Development Manager
> Phone : 02 4229 1185
> Mobile : 0412 926 995
> Email : grant at sitedoc.com.au
> Web : www.sitedoc.com.au
>
> SiteDoc - Easy to Use - Powerful Results
>
> _______________________________________________
> Delphi mailing list
> Delphi at ns3.123.co.nz
> http://ns3.123.co.nz/mailman/listinfo/delphi
>