[DUG] FastMM4

[Ross Levis]

I have a strange problem I just noticed.  I'm using D7 with FastMM4 manually
installed, and have it as the first Uses entry in the dpr file.

 

I loaded the unit by ctrl+clicking the unit name in the dpr file (to ensure
it's the correct source code I'm looking at).  I placed a break point on the
first line of code in the initialization section.  But when I compile and
run, the break point line has the red X showing that the line is never
executed.  I can't understand it.

 

I've searched the whole hard drive  and there is no other unit anywhere.
Deleting the DCU file caused it to be recreated when compiling, but the code
never appears to execute according to the ide/debugger.

 

I'm very sure this use to work, and stepping through Move operations would
load the fastmm4 unit, but not anymore.  Any ideas?

 

Thanks,

Ross.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://www.adventureeducation.co.nz/pipermail/delphi/attachments/20070716/2f4b9f91/attachment.html